Bolens 452 Thru 465 warranty Attaching The Chipper Chute, To the frame. See Figure

3		7. The chipper shredder was shipped with one end of
		the support brace already secured to the lower frame.
		Loosen but do not remove the bolts securing the brace
		to the frame. See Figure 3-7.
		a. Align the holes in the chute with the holes in the top
		of the brace and attach brace to chipper chute with
Setting Up	A	hardware previously removed. Tighten securely.
		b. Tighten the bolts securing the support brace to the
Your Chipper		frame.
Shredder		c. Tighten the three nuts on the weld studs holding
		the chipper chute to the impeller housing.
	B	Attaching The Chipper Chute
		(Model Series 450)
	C
		8. a. Remove the three cupped washers and hex nuts
		from weld studs around the opening on the side of
IMPORTANT	Figure 3-7	the impeller housing. See Figure 3-8.
This unit is shipped
without gasoline or
oil in the engine. Be
certain to service
engine with gasoline
and oil as instructed
in the separate engine
manual before operat-
ing your machine.
NOTE: All references
in this manual to the
left or right side of
the chipper shredder
is from the operating
position only. Excep-	Figure 3-8
tions, if any, will be
specified.

NOTE: This Operators Manual covers a range of product specifica- tions for various models. Characteristics and features discussed and/or illustrated in this manual may not be ap- plicable to all models. MTD LLC reserves the right to change product specifications, designs and equipment without notice and without incurring obligation.