Pioneer RCS-505H, RCS-606H, RCS-404H manual Additional information, Tuner, Error Messages

Additional information 07

Problem	Remedy
Can’t operate using the remote	• Replace the batteries (Putting the batteries in the remote control on page 17).
control.	• Operate within 7 m, 30° of the remote sensor (Using the remote control on page 17).
	• Remove any obstacles or operate from another position.
	• Avoid exposing the remote sensor on the front panel to direct light.
	• For operating the DVD recorder, make sure that the control cable and coaxial cable are
	connected. (page 10)
	• If the receiver subwoofer is connected to a Pioneer plasma display with an SR+ cable,
	check that the plasma display is switched on. Point the remote control at the plasma
	display in order to operate the receiver subwoofer.
	• Check that nothing is mistakenly plugged into the CONTROL IN jack.

Tuner

Problem	Remedy
Considerable noise in radio	• Connect the AM antenna (refer to the Connecting up) and adjust the direction and
broadcasts.	position for best reception. You may also connect an additional internal or external AM
	antenna (refer to Connecting external antennas on page 34).
	• Fully extend the FM wire antenna, position for best reception, and secure to a wall. You
	may also connect an outdoor FM antenna (see Connecting external antennas on page 34).
	• Turn off other equipment that may be causing the noise or move it further away.
Auto tuning does not pick up	• The radio signal is weak. Auto tuning will only detect radio stations with a good signal.
some stations.	For more sensitive tuning, connect an outdoor antenna.

Error Messages

Message	Description
2CH ONLY	• An operation is prohibited because it is only applicable to 2 channel sources, while the
	current source is a multichannel source.
96K	• An operation is prohibited because the source is 96 kHz digital.
EXIT	• Appears when a menu is automatically exited after a set period of inactivity.
NOISY	• Background noise is too high to complete MCACC setup successfully.
ERR MIC	• An error occurred during MCACC setup because the microphone is not connected or is
	not connected properly.
ERR SP	• An error occurred during MCACC setup because the speakers are not connected or are
	not connected properly.
EEP ERROR	• Contact your Pioneer authorized service center or your dealer for servicing.
NO SPTYP	• Try switching the unit off then on again. If the error still appears, please contact a
	Pioneer authorized service center or your dealer.

English

39

En