SECTION 8: TROUBLESHOOTING GUIDE
Problem |
| Cause |
| Remedy |
|
|
|
|
|
Engine fails to start | 1. | Fuel tank empty, or stale fuel | 1. | Fill tank with clean fresh gasoline. |
| 2. | Blocked fuel line | 2. | Clean fuel line |
| 3. | Key not in ON position | 3. | Insert key and turn to ON position |
| 4. | Spark plug wire disconnected | 4. | Connect wire to spark plug. |
| 5. | Faulty spark plug | 5. | Clean spark plug, readjust gap, or |
| 6. | Engine not primed |
| replace. |
| 7. | Engine flooded with excessive priming | 6. | Prime engine four times. |
|
|
| 7. | Wait at least ten minutes before |
|
|
|
| starting. |
Engine runs erratic | 1. | Unit running on choke | 1. | Move choke lever to OFF position. |
| 2. | Fuel line blocked, or stale fuel | 2. | Clean fuel line and fill tank with fresh, |
|
|
|
| clean gasoline. |
| 3. | Water or dirt in fuel system | 3. | Refer to engine manual for remedy. |
| 4. | Carburetor out of adjustment | 4. | Refer to engine manual for remedy. |
Engine overheats | 1. | Carburetor out of adjustment | 1. | Refer to engine manual for instruction. |
Loss of power | 1. | Spark plug wire loose | 1. | Connect and tighten spark plug wire. |
| 2. | Vent in gas cap plugged | 2. | Clear vent. |
Excessive vibration | 1. | Loose parts or damaged auger | 1. | Stop engine immediately and |
|
|
|
| disconnect spark plug wire. Check for |
|
|
|
| possible damage. Tighten all bolts |
|
|
|
| and nuts. Repair as needed. If the |
|
|
|
| problem persists, take unit to an |
|
|
|
| authorized service dealer. |
Unit fails to self- | 1. | Drive cable out of adjustment | 1. | Adjust control cable following |
propel |
|
|
| instructions on page 9 of this manual. |
| 2. | Drive belt loose or damaged | 2. | Replace drive belt. |
Unit fails to | 1. | Discharge chute clogged | 1. | Stop engine immediately and |
discharge snow |
|
|
| disconnect spark plug wire. Clean |
|
|
|
| discharge chute and the auger |
|
|
|
| housing. |
| 2. | Foreign object lodged in auger | 2. | Stop engine immediately and |
|
|
|
| disconnect spark plug wire. Remove |
|
|
|
| object . |
| 3. | Control cable not adjusted properly | 3. | Adjust control cable following |
|
|
|
| instructions on page 9 of this manual. |
| 4. | Drive belt loose or damaged | 4. | Replace drive belt. |
NOTE: For repairs beyond the minor adjustments listed above, contact your nearest authorized service representative or call
11
