Bolens Series 080 manual 10

2.	Ifsatisfiedwiththeheightofthehandle,tightenthestarknobs 3.	Position the recoil starter by following the steps below:
	at the ends of the lower handle shown in Fig. 3-3. For	a.	Hold the blade control against the upper handle.
	convenience of operation, you may adjust the handle
		b.	Slowly pull the starter rope out of the engine. See Fig.
	height as follows:
			3-4.

A

BD

C

Figure 3-3

NOTE: Each end of the lower handle must be placed in the same position on the mounting brackets.

a.Remove the star knobs shown in Fig. 3-3 and remove the lower handle.

b.Position each handle bracket stud into the top hole in the lower handle.

c.Tighten the star knobs.

Figure 3-4

c.Slip the starter rope into the rope guide.

d.Tighten the rope guide wing nut.

4.Use the cable tie provided to secure cable to the lower handle. Pull the cable tie tight and trim excess. See Fig. 3-5.

Figure 3-5

10Section 3 — Assembly & Set-Up