11 | 6 |
|
.engineer service a call then occur, to continues condition this If .interrupted been not has supply gas the that Check .back and
TO LIGHT AND STOP THE
APPLIANCE
INDICATOR LIGHTS
Boiler demand : | System is calling for heat | |
Burner ON | : | Burner is firing |
| : | There is a fault condition |
|
| Steady light - Overheat |
|
| Flashing light - Flame failure |
TO LIGHT THE APPLIANCE
Check that the water valves to the central heating circuit are open. Check that the needle on the pressure gauge is not below the
required pressure - sealed system only.
Switch on the mains electricity. Set the room thermostat, if fitted, to maximum. Turn the boiler temperature control fully clockwise to the maximum position. The burner will light. Set the boiler temperature control and the room thermostat/cylinder thermostat, if fitted, to the desired temperature.
TO STOP THE APPLIANCE
For Short Periods
Turn the boiler temperature control fully
For Long Periods
Turn the boiler temperature control switch to the ‘O’ position. Switch off the mains electricity.
Any programmer will require resetting if mains supply has been disconnected.
ELECTRICITY SUPPLY
FAILURE
If the electricity supply fails the appliance will not operate. Once the supply is restored the appliance will return to normal operation.
Check that the settings of any programmer or time control have been maintained.
.setting the alter not Do .load heating the suit to installer the by set be will it so If .adjuster speed a with fitted be may which pump circulating a with filled be will system heating The PUMP CIRCULATING
.damaged or obstructed become to wall outside the on fitted terminal flue the allow not Do TERMINAL FLUE
.BS5440 with accordance in ventilated be must compartment the then compartment unvented an for shown than less are clearances the If .6798:1987 BS in described as partition
.valve radiator thermostatic a by controlled be must sited is thermostat room the where room the in located radiator The .BS2767 of requirements the to conform must they then system the to fitted are valves radiator thermostatic If VALVES RADIATOR THERMOSTATIC
.control the with supplied instructions the to Refer .manufacturer and type the with varies setting of method the system: the to fitted been have may clock or programmer A PROGRAMMER/CLOCK
.thermostat room the with supplied instructions the to Refer .manufacture and type the with varies thermostat room a setting of method The .home the of room one in located be will It .temperature heating central the of control for fitted be may thermostat room A THERMOSTAT ROOM
FROST PRECAUTIONS
If the appliance is not to be used for a long period of time and there is a likelihood of freezing, then the appliance should be drained. The Worcester Technical Helpline will advise you on suitable frost precautions. The boiler has an
SERVICE
Annual servicing is important in order to ensure continuing high efficiency and long life for your appliance. In the event of any difficulty in making suitable servicing arrangements, Worcester personnel or other competent persons will discuss regular servicing arrangements and offer a comprehensive maintenance contract.
WARNING
If a gas leak exists, or is suspected, turn off the gas supply to the appliance at the service cock on the meter and consult your local service engineer.
Do not touch any electrical switches to turn them either on or off. Open all windows and doors. Do not smoke. Extinguish all naked lights.
CLEANING
Do not use abrasive cleaners on the outer casing. Use a damp cloth and a little detergent.
10 | 7 |