Using the remote control
while turning on the power switch (I). Release program key when LCD displays “188”.
LCD shows “P2”. If not, repeat previous step.
B Select “P3” using buttons and on heater.
B Press and hold Program key
or again for 1 sec.
LCD shows one number and one rotating digit. If not, repeat previous step.
The number represents the remote control which is to be registered, the first remote control will be registered with number “0”, the second with number “1” and so on.
The rotating digit shows that the electronics is expecting a registration. If the LCD fails to show a number and rotating digit after repeated attempts, double check the wire connections made in section 4.2.
B Hold remote control in front of the control panel on the heater and press simultaneously remote control
buttons and until the temperature indication is shown on the remote control LCD.
B Switch power switch on the appliance to the "OFF" (0) position and then back "ON" (I).
B Press buttons or in order to reach requested temperature.
New remote control is programmed.
4.3.2 SU board
BConnect power to heater.
B Move the main switch on the appliance to the "OFF" (0) position.
BPress and hold key while at the same time turning the main switch to “ON” position (I).
LCD shows one number and one
rotating digit. If not repeat previous
step.
The number represents the remote
control which is to be registered, the
first remote control will be registered
with number “0”, the second with
number “1” and so on.
The rotating digit shows that the
electronics is expecting a registration.
If the LCD fails to show a number and
rotating digit after repeated attempts,
double check the wire connections
made in section 4.2.
B Hold remote control in front of the control panel on the heater and press simultaneously remote control
buttons or until the
8 | 6 720 606 990 |