Using the remote control
BReplace the control unit cover with the 4 Philips head screws (Fig. 5, pos. 1).
BSlide control unit back into heater.
BPlug 2 yellow electrode wires from the top of the control unit back onto the ignition electrodes (Fig. 3, pos. 3).
i | Wire polarity does not | |
matter on the electrode | ||
| ||
| wires. | |
|
|
BPull end of power cord to take up excess slack and tighten retaining nut on the bottom of the heater.
B Reinstall the two electrical strip connectors onto the PCB. The larger connector connects to the lower connection on the PCB. Reseat the rubber seals for both connectors.
B Replace the control unit auxiliary cover. (Fig. 3, pos. 4).
BReplace front retaining bar using 5 Philips head screws. (Fig. 3, pos 1).
4.3Remote control activation
i | Before | the | remote | |
control will work, it must | ||||
| ||||
| be activated | using the | ||
| procedure |
| described |
below with the operator standing in front of the appliance.
The remote control initialization instructions vary based on the version of control board installed in your heater.
To determine the control board version in the water heater:
BTurn power switch on the water heater to the off position (O).
BWhen turning power switch to the on position, note the first two letters that appear on the display (should be AF or SU).
BIf the letters are AF, follow section 4.3.1. For SU, follow chapter 4.3.2.
4.3.1 AF board
BConnect power to heater.
B Move the power switch on the appliance to the off position (0).
B On heater control panel press and
hold Program key or
6 720 606 990 | 7 |