Bosch Appliances 3540 manual Starting and Stopping, Making a flat cut, Scale Rule

SM_2610008271_12-09:tile saw 12/17/09 3:25 PM Page 13

operation

Starting and Stopping

To reduce the risk of electrocution, keep ! DANGER all connections dry and off the ground. Do

not touch plug with wet hands.

To reduce the risk of electric shock, plug ! WARNING tile saw into Ground fault circuit

interrupter (Gfci) protected outlet only. if a Gfci protected outlet is not available, use a portable receptacle with built-in Gfci protection.

To reduce the risk of electric shock, ! WARNING always test Gfci to make sure it is

functioning properly before plugging tile saw into Gfci protected receptacle.

Connect the unit to a power source with the correct voltage and frequency (120V, 60Hz).

FIG. 7

oN

off

To start the saw: push the switch to “1” (ON) position (Fig. 7).

To stop the saw: push the switch to “0” (OFF) position (Fig. 7).

making a flat cut

1.Adjust the top guard/splash hood to slightly higher than the workpiece and tighten knob to secure.

2.Adjust the parallel rip fence to the desired distance from the tile blade, using the scale rules on the table surface for reference. Tighten the fence-locking knobs on each side to firmly lock the parallel rip fence on the table. (Fig. 8)

3.Place the work piece against the parallel rip fence, and feed the tile into the tile blade with a steady even pressure (forcing the tile will cause the blade to slow which could cause motor overheating). (Fig. 9)

4.Turn saw off when cutting is complete.

Never place your hand or fingers in the ! WARNING path of the tile blade.

FIG. 8

fence

Scale Rule

locking Knob

FIG. 9

13.