Bosch Appliances 3540 manual Making a miter cut, Making a Bevel cut, After Use, Guide

! WARNING

SM_2610008271_12-09:tile saw 12/17/09 3:25 PM Page 14

operation

making a miter cut

1.Adjust the parallel rip fence to the desired distance from the tile blade, using the scale rules on the table surface for reference. Tighten the fence-locking knobs on each side to firmly lock the parallel rip fence on the table. (Fig. 8)

2.Use the angle guide supplied in conjunction with the parallel rip fence.

3.Select the desired angle and tighten the screw to secure the angle guide (Fig. 10).

4.Place the tile against the angle guide. (Fig. 10).

5.Hold the tile firmly against the angle guide and feed it slowly toward the rotating tile blade.

making a Bevel cut

1.Loosen the bevel cutting knobs on both sides of the table (Fig. 11).

2.Tilt the table to the desired angle, using the scale for reference.

3.Tighten the bevel cutting knobs.

4.Follow the instructions for making a flat cut (Fig. 12).

To avoid possible injury, the rip fence should only be used on the right side of

the table while making a bevel cut.

after Use

•Verify the ON/OFF switch is in the OFF position.

•Unplug the tile saw from the power source.

•Clean the tile saw after each use.

•Emtpy and clean water trough.

•Wipe off all exterior surfaces and tile blade.

FIG. 10
angle	angle
Guide	Guide
Knob

FIG. 11

Bevel

Knob

FIG. 12

14.