aus
Washing dishes
Reduce costs!
If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice.
Programme data
The stated programme data are based on standard operating conditions. The values can vary considerably according to:
different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage
Switching on the appliance
| Close the door. |
|
|
|
|
| |
|
|
|
|
|
| ||
| Turn on the tap fully. |
|
|
|
|
| |
|
|
|
|
|
| ||
| Rotate programme selector |
|
|
| to the | ||
|
| 3 |
| ||||
| |||||||
| required programme. |
|
|
|
|
| |
| Switch on the main switch |
|
| . |
|
| |
|
| 1 |
|
| |||
|
|
| |||||
The programme sequence display |
|
| |||||
6 |
|
lights up, the programme sequence starts automatically.
End of programme
The programme ends when
the Programme progress indicator
6has gone out and
the
7illuminates. When the programme ends, the ºTop basket washingº function is
Several minutes after the programme has ended:
Open the appliance door.
Wait until the dishes have cooled down and then remove.
When the programme has ended, you can either switch off the appliance or restart it with the same or another programme.
Switching off the appliance
Several minutes after the end of the programme:
Switch off the main switch |
| 1 | . | |
ºEnd of programmeº display |
|
| ||
| 7 | |||
goes out. |
|
|
|
Turn off the tap
(does not apply to Aqua Stop). It is not necessary to adjust the programme selector.
Remove the utensils when they have cooled down.
Interrupting the programme Set the main switch 1 to OFF. Indicator lights extinguish.
If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may fly open due to expansion.
In order to resume the programme, set the main switch to ON again.
16