aus
Installation
The dishwasher must be connected by a qualified technician to ensure correct operation. The specifications for supply, drainage and connected load must fulfil the required criteria as stated in the following paragraphs or in the installation instructions.
Install the appliance in the following sequence:
±Check the delivery
±Install the appliance
±Connect the waste water
±Connect the fresh water
±Connect the power supply
Delivery
Your dishwasher was checked at the factory to ensure that it was in perfect working order. This may have left some small water stains in the dishwasher. These will disappear after the first rinse cycle.
Installation
The required installation dimensions can be found in the installation instructions. Using the
Waste water connection
See the installation instructions for the required connection steps. If required, attach a siphon with drainage spigot.
Using the enclosed parts, connect the waste water hose to the drainage spigot of the siphon.
Ensure that the drainage hose is not kinked, crushed or twisted (ensure that there is no sealing cover which prevents the waster water from flowing away!).
Fresh water connection
Using the enclosed parts, connect the fresh water connection to the tap according to the installation instructions. Ensure that the fresh water connection is not kinked, crushed or twisted.
When replacing the appliance, always connect a new water supply hose to the water supply. The old supply hose must not be
Water pressure:
Minimum 0,05 MPa (0,5 bar) ± maximum 1 MPa (10 bar).
If the water pressure is higher, install a pressure reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend cold water connection only.
Electrical connection
This appliance should only be connected to a 240 V AC source via a properly installed earthed socket. See nameplate for size of required fuse.
The socket must be installed close to the dishwasher.
If you need to extend the mains connecting lead, do not cut off the plug. Replace the whole cable, which can be disconnected at the junction box on the rear of the appliance.
If the domestic wiring includes a residual-
sure that it bears the 
mark, as only this type conforms to the latest regulations
24
