Getting Started
System Information (sysinfo) Page
To display system configuration and status information type the command sysinfo at prompt.
#> sysinfo
[Hardware Version] 5580
[MVC Version] 3893mvc_4p5_050913.arm [Firmware Version] 2p0r8D06011801
[Device ID] 00 01 DE 00 04 47 [Base ID] 1 [AP ID] 1 [SU ID] 1 [System Up Time] 0 day(s) 00:22:51
[Opmode] off [Default Opmode] off [Opmode Start] 30 sec
[IP] 192.168.100.100 [Subnet Mask] 255.255.255.0 [Gateway] 192.168.100.1 [Httpd Port] 80 [Httpd Status] listen
[Telnetd Port] 23 [Telnetd Status] connected
[Telnet Client #1] 192.168.100.111,1093
[Telnet Client #2] 192.168.100.111,1092
[Telnet Client #3] 192.168.100.111,1088
[Telnet Client #4] 192.168.100.111,1087 [Tftpd] disabled
[RF Tx Power] 21 dBm
Channel Table: (MHz)
[Ch#01] 5736 [Ch#02] 5756 [Ch#03] 5776 [Ch#04] 5796 [Ch#05] 5816 [Ch#06] 5836
[Ch#07] 5736 [Ch#08] 5736 [Ch#09] 5736 [Ch#10] 5736 [Ch#11] 5736 [Ch#12] 5736
[Ch#13] 5736 [Ch#14] 5736 [Ch#15] 5736 [Ch#16] 5736 [Ch#17] 5736 [Ch#18] 5736
[Ch#19] 5736 [Ch#20] 5736 [Ch#21] 5736 [Ch#22] 5736 [Ch#23] 5736 [Ch#24] 5736
[Ch#25] 5736 [Ch#26] 5736 [Ch#27] 5736 [Ch#28] 5736 [Ch#29] 5736 [Ch#30] 5736
[Channel Scan Sequence] 5 v [Active Channel] 5 v Disconnected
[Broadcast Packet] on [Auto Scan AP] on [TCP/IP for AP] off [TCP/IP for Local Et h] off
[Remarks] Remarks [ARQ] on
[RF Rx] 0 Kbps [RF Tx] 0 Kbps [Eth Rx] 3 Kbps [Eth Tx] 101 Kbps
[Eth Rx] 51,723 bytes [Eth Tx] 64,975 bytes [RF Rx] 0 bytes [RF Tx] 0 bytes
Success.
#>
Note: Four open Telnet sessions indicated in bold within the sysinfo displayed above For more information, see table #3 below.
Trango Broadband Wireless — | page 8 |
