Appendix BSpecifications
Appendix B Command Set Summary
ver | Command | Displays current firmwareDescriptiversion, MVC and hardware | Remarks | |
Apsearch |
| Searchversifonr near by APs. |
|
|
arq [onoff] |
| enable or disable ARQ | default on | |
Bye |
| Terminate or exit telnet/serial session |
|
|
Exit |
| Terminate or exit telnet /serial session |
|
|
freq [<ch#> <antenna>] | set or display channel settings | default 1 h | ||
freq scantable | Displays current scan table |
|
| |
freq channeltable | Displays current channel table |
|
| |
freq writescan <ch> <h/v> … | Creates channel scan table |
|
| |
freq writechannel <ch#> <freq>… | modify channel table, up to 30 channels | Opmode off only | ||
help [<command>] | display commands and proper usage |
|
| |
ipconfig [<ip> <subnet> <gateway>] | change ip configuration | default: | ||
|
| <ip> = ip address | IP 192.168.100.100 | |
|
| <subnet> = subnet mask | SN 255.255.255.0 | |
|
| <gateway> = gateway ip address | GW 192.168.100.100 | |
log [<# of entries, 1..179> |
|
|
| |
log <sum> <# of entries, 1..179> |
|
|
| |
Logout |
| Exit telnet session |
|
|
|
|
| ||
opmode [offsu [y]] | set or display opmode | default off | ||
password <rorwupgrade> | Change password | default trango | ||
|
| <ro> = for |
|
|
|
| <rw> = for |
|
|
|
| <upgrade> = for upgrading firmware |
|
|
ping <ip address> | Ping ip address |
|
| |
polar <h/v> |
| Sets antenna polarization | Default: h | |
power [<dBm>] | set or display tx power <dBm> | Default 21 | ||
pppoeonly <on/off> | Set radio to allow pppoe traffic only | Default off | ||
Reboot |
| reboot unit |
|
|
remarks [<str>] | remarks, up to 80 characters |
|
| |
reset [all0..2] | reset all parameters to factory defaults |
|
| |
|
| reset 0 XXXX parameters only |
|
|
|
| reset 1 XXXX parameters only |
|
|
Rssi |
| display RSSI for AP / SU and association status | Opmode on only | |
set apid <id> |
| Sets AP ids | Default: 1 | |
set baseid <id> | Sets unit base id (Numeric Characters only 0 – 9) up to | Default: 1 | ||
|
| 999 |
|
|
set suid <id> |
| sets SUs id | Default: 1 | |
set httpport [<1…65534>] |
|
|
| |
set telnetport [<1…65534>] |
|
|
| |
ssrssi [ch, h/v>] | Search for best signal on a channel while in opmode off |
|
| |
survey <time, sec> <h/v> | Survey for a clean |
|
| |
sw [<sw #> <on/off>] | Sets switches on or off |
|
| |
Sysinfo |
| Displays system current information |
|
|
syslog [<0/1> clear] |
|
|
| |
tftpd [onoff] |
| enable or disable tftpd | default = off | |
|
|
| enable for firmware | |
|
|
| upgrade | |
tm |
|
|
|
|
|
|
|
|
|
Trango Broadband Wireless — | page 28 | |||
