Using the HTTP Interface
Chapter 4 Using the HTTP Interface
This section describes a few more basic concepts and how to establish a basic wireless link with the AP,
using the Browser (HTTP) Interface. This section addresses only the most basic steps in establishing a link in the lab, or a
Configure Basic Parameters
Each SU must be set up with basic information to communicate with the AP. At a minimum the Base ID must match the Base ID of the AP, the SU ID must match the SU ID in the AP.s SUDB, and the AP.s active channel must exist in the SU.s AP Scan Sequence.
To set up the SU, complete the following steps:
1.Connect to the SU (see Chapter two “Getting Started”), and open the Configuration page.
2.Open a browser session and type the IP address of the radio at the address bar of the browser. Default IP address is 192.168.100.100.
3.Leave the User name field blank and enter read write or read only Password. Press or Click OK. Default password is trango. After logging on, the system information screen will be displayed.
Figure 8
Trango Broadband Wireless — | page 15 |
