Trango Broadband M5580M-FSU user manual Configuration Tools, Troubleshooting Ethernet Connections

Getting Started

Configuration Tools

M5580M-FSU radios can be configured using either the Command Line Interface (CLI), or the Web Browser (HTTP) interface. Although both methods are comprehensive and powerful, the CLI method provides slightly more functionality.

This text covers configuration through the CLI. For HTTP configuration please see Chapter 4 on page 18.

Telnet

Open a command prompt (DOS) session on your PC. Next, open a Telnet session by typing:

telnet <ip address of radio>

Example:

C:>telnet 192.168.100.100

Note: All Trango radios are pre-configured at the factory with a default IP address of 192.168.100.100, Subnet Mask 255.255.255.0, and Default Gateway 192.168.100.100.

Note: The M5580 can handle up to 4 telnet sessions.

You will be greeted with current hardware and firmware information and prompted for a password. Type in the password and press enter. The factory default read/write password is trango.

Welcome to Trango Broadband Wireless, M5580M 2p0r8D06011801 Password:

Note: Type help for a listing of all CLI commands. Type help [<command>], for the syntax of a particular command.

Note: If you cannot access the radio management functions via the Ethernet port, check all cable connections and ensure that your PC is set up with a correct IP scheme.

Troubleshooting Ethernet Connections

If you cannot telnet into the radio or open an HTTP browser session, check your cable connections to ensure proper use of cross-over vs. straight-through cable, and ensure your PC’s subnet is routable to the radio’s IP address. You can also, try pressing and holding the reset button on the unit to ensure default IP address and password.

Trango Broadband Wireless — M5580M-FSU (Atlas Fox) User Manual Revision 2 page 7