Configuration
| to execute commands from the | #>Set suid 3 |
|
|
| AP to this specific SU. |
|
|
|
AP ID | Informational parameter that | Informational Parameter |
|
|
| shows to which AP the SU is |
|
|
|
| associated. Please note that |
|
|
|
| AP ID is not used by the |
|
|
|
| system for SU authentication. |
|
|
|
Opmode | Current Opmode of radio. | opmode su [< y>] / off |
|
|
|
| This sets the radio in Opmode “SU.” Or OFF |
| |
|
|
|
| |
Default Opmode | Determines the Opmode (“SU” | set defaultopmode <su off> |
| |
| or “OFF”) of the radio after |
|
|
|
| reboot/power cycle. When the | Example: #>set defaultopmode ap |
| |
| parameter is set to “SU,” the |
| ||
| radio will progress into |
|
|
|
| Opmode “SU” automatically |
|
|
|
| fter reboot/power cycle. |
|
|
|
IP | IP, Subnet, and Gateway | ipconfig [<new ip> <new subnet mask> <new |
| |
Subnet | address of radio. | gateway>] |
|
|
Gateway |
| Example: #>ipconfig 10.1.1.3 255.0.0.0 10.1.1.1 |
| |
|
|
| ||
TFTPD | TFTPD status (on or off). | tftpd [<on off>] |
|
|
| TFTPD should be turned on to |
|
|
|
| import file into radio (such as |
|
|
|
| new firmware). Default is off. |
|
|
|
| TFTPD will revert to off after |
|
|
|
| reboot/power cycle. |
|
|
|
|
|
|
| |
RF TX Power | Current transmit power of the | power set <dBm> (Range is 7..21) |
| |
| SU not including antenna gain. |
|
|
|
| This is controlled during the |
|
|
|
| association process. |
|
|
|
|
|
|
| |
Channel Scan Sequence | Shows the various channels (in | freq scantable (displays scan table) |
| |
| sequence) that the SU will | freq scantable 5 v (sets | Scan table to 5 v) |
|
| scan while searching for an |
| ||
| AP. |
|
|
|
|
|
|
|
|
Active Channel | Shows the channel used in the | Information Parameter |
|
|
| current association, and |
|
|
|
| "Associated" or |
|
|
|
| "Disconnected" depending on |
|
|
|
| the association status. |
|
|
|
Broadcast Packet Filter | This software switch (0) | sw 0 [<on off>] (default is on) |
| |
| enables/disables the blocking |
|
|
|
| of Ethernet control packets, | Example: |
|
|
| except ICMP and ARP, to | #>sw 0 on |
|
|
| reduce the amount of |
|
|
|
| unnecessary overhead |
|
|
|
| introduced to the wireless link. |
|
|
|
|
|
|
|
|
|
|
|
|
|
Trango Broadband Wireless — | page 11 |
| ||
