44 en Subsystem Maintenance | RAID Subsystem |
|
|
Levers
Fig. 6.2 Removing the Controller Module
6.2.3Replacing the Controller Module
If the controller module itself has failed, it must be replaced. To replace a failed controller module:
1.Remove the controller module from the subsystem (see Section 6.2.2 Removing the Con- troller Module.) If the DIMM module is undamaged it can be removed and reinstalled on the new controller module. For instructions on removing and installing a DIMM module, please see Section 6.3 DIMM Module Replacement.
2.Install the DIMM module onto the new controller module, making sure that the memory module is securely in place. (See Section 6.3 DIMM Module Replacement)
3.Install the controller module. Make sure the levers at the back of the controller module are down. Align the controller module with the controller module bay at the rear of the subsystem. Gently slide the controller module in. (See Section 6.3 Installing the Controller Module)
Levers
Fig. 6.3 Installing the Controller Module
4.Reposition the controller module. Once fully inserted, lift up the levers at the back of the controller module. This will set the controller module in the correct position. (See Figure 6.4)
Levers
Fig. 6.4 Lifting the Controller Module Latches Upward
5.Secure the controller module to the subsystem. Install the two (2) screws on the levers to secure the controller module in place. (See Figure 6.5)
F.01U.027.799 V2 2008.08 | Bosch Security System |
