no flour or oil on the surface. A clean smooth surface will provide the best footing for the suction cup feet on the power unit and will limit slipping and/or “walking.”
2.Plug power unit into power supply. Unwind the power unit’s cord to appropriate length and plug it into a convenient nearby receptacle.
3.Remove motor drive cover. Remove motor drive cover from mono- drive, see figure 2c.
4.Select attachment to be used. Select attachment you wish to use and place on power unit. See specific instructions for attachment selected. Specific instructions are located on pages listed below:
Attachment | Pages |
|
|
Mixing bowl w/dough hook | ........ |
Mixing bowl w/twin whisks | ....... |
Blender | |
Slicer/shredder | |
Food processor | |
|
|
Table 1.
5.Operate unit with rotary switch. Once the attachment is in place, the speed of its moving components can be controlled through the use of the rotary switch at the front of the power unit. See figure 2a. The rotary switch has six positions:
a.“M,” a momentary “pulse” position that provides full speed and power for the time it is held in position.
b.“O/Off,” the off position.
and
c.Four speeds labeled 1, 2, 3 and 4. Speed 1 is the lowest speed. The speed increases with each succeeding step up to the highest speed, speed 4.
All models of the Bosch Concept Series Kitchen Machines incorporate an electronic safety control to protect the motor. If the safety becomes activated, the indicator will flash. See TROUBLESHOOTING at the back of this manual if status indicator is flashing.
Figure 3.
6.Turn power unit off.
When your work with the attachment is completed or the capacity of the batch feed attachment has been reached, turn the power unit to off position, “O/Off” and unplug.
7.Remove the attachment. Remove the attachment from the power unit, per instructions for the specific attachment being used.
8.Continue use.
If the attachment was of the batch feed type and you wish to continue using the attachment, empty the bowl or jar of the attachment per its specific instructions and reinstall the attachment as before. Repeat the steps 5 through 7 as often as necessary to complete necessary work.
9.Work completed, remove attachment.
If the attachment is of the continuous feed type or is the batch type and you have completed the work you wished
8
