ASSEMBLY
•Assembly requires two persons.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.
•After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild,
•To identify small parts, see page 6.
•Assembly requires the following tools:
the included hex keys one adjustable wrench one Phillips screwdriver scissors needlenose pliers
To avoid damaging parts, do not use power tools.
1. Make sure that the power cord is unplugged. | 1 |
|
|
|
|
| |
Locate the Upright Wire (70) bundled around |
|
|
|
the front of the Base (80) beneath the Belly Pan |
|
|
|
(68). Cut the plastic tie securing the Upright |
|
|
|
Wire. Then, route the Upright Wire into the |
|
|
|
Base and out of the indicated hole. |
|
|
|
Press a Base Cap (77) into each side of the |
|
|
|
Base (80). |
|
|
|
See the inset drawing. Cut the plastic tie near |
|
|
|
the Upright Wire (70). Be careful not to dam- |
|
|
|
age the Upright Wire. |
|
|
|
| 80 | 68 |
|
|
| 70 | |
|
| Cut | |
|
|
| |
|
| Hole | Tie |
|
| 77 | Cut |
|
|
| |
|
|
| 70 |
7
