8. IMPORTANT: To avoid damaging the Pulse |
Crossbar (31), do not use power tools and do |
not overtighten the #10 x 3/4" Screws (13). |
Orient the Pulse Crossbar (31) as shown. Attach |
the Pulse Crossbar to the Handrails (71) with |
four #10 x 3/4" Screws (13) and four #10 Star |
Washers (11). Start all four Screws, and then |
tighten them. |
Make sure that the Upright Wire (70) is not |
pinched. Firmly tighten the four 5/16" x 2 3/4" |
Screws (10). |
9. With the help of a second person, hold the con- |
sole assembly near the left Handrail (71) and the |
right Handrail (not shown). |
Connect the ground wire from the console |
assembly to the Console Ground Wire (89) on |
the Pulse Crossbar (31). |
Connect the Upright Wire (70) to the console |
wire. See the inset drawing. The connectors |
8 |
|
| 13 |
|
|
| |
|
|
| 71 |
|
|
| 11 |
|
|
| 31 |
| 70 | 13 | 10 |
|
| ||
|
|
| |
| 11 |
|
|
|
|
| 71 |
| 10 |
|
|
9 |
|
| Console |
|
|
| |
|
|
| Assembly |
should slide together easily and snap into |
place. If they do not, turn one connector and try |
again. IF YOU DO NOT CONNECT THE CON- |
NECTORS PROPERLY, THE CONSOLE MAY |
BECOME DAMAGED WHEN YOU TURN ON |
THE POWER. Then, remove the wire tie from |
the Upright Wire. |
Ground
Wire
89
Console
Wire
70
70 
31
Wire
Tie
Console
Wire
71
11
