10 Operation | |
|
|
6.Secure the housing to the mount by attaching two
NOTE! The outermost set of
i and the innermost
6.1Installing the Camera Tray
Verify operation of the camera and lens and adjust the camera focus and iris as necessary. See the instruction manual for your specific camera.
Installing the Camera Tray
1.Slide the camera tray with attached camera (see Section 5.5: Attaching the Camera and Spacer to the Tray) into the slot of the housing.
2.Secure the camera tray with screw.
6.2Connecting the Wires
Before proceeding, verify that the BNC for the Video Coax Cable is separated from the mains power connections / circuitry and there is a physical spacing barrier between cables. For wir- ing video coax connections, use only the cables specified in Section 4: Cable Requirements.
Connecting the Wires
1.Attach the BNC connector to the coax.
2.Connect the coax cable to the camera.
3.Connect the power leads from the source to the terminated block.
4.Connect the wires from the terminal block to the camera.
5.Tighten the fittings to 8.5 N.m to 9.0 N.m (75 in. lb to 80 in. lb). The torque rating is approximately 1 to
•Tighten all fittings to ensure a
•If a sealant is used, be sure it is a neutral cure type. Sealants that release acetic acid may harm camera electronics.
•Use of drip loops is recommended on the wiring outside of the rear end cap.
6.Use the provided hole plugs to plug any unused holes.
7.Close the cover and secure the
7 Operation
These housings require no operational adjustments other than camera/lens adjustments.
8 Maintenance
No special maintenance is required other than occasional cleaning of the window. The win- dow can be cleaned with water or any non aggressive liquid. Regularly scheduled maintenance will help prolong the operation life of this unit. Clean the viewing window as needed with a mild, nonabrasive detergent in water and a soft cloth.
September 15, 2006 F01U032279_01 | Installation Manual | Bosch Security Systems, Inc. |