Bosch Appliances UHI-SBG-0 installation manual Mounting the Housing, Mounting Procedure

UHI-SBG-0 Series Mounting the Housing 9

6 Mounting the Housing

The UHI-SBG-0 housing includes a J-mount which features a removable camera bracket and locking grooves to keep the housing from drooping. The mount is vertically adjustable by pushing the housing up or down.

Mounting Procedure

1.Determine a proper location for the housing.

2.Insert the coax and power lead wires from the wall through the supplied J-mount allow- ing enough slack to pull through the housing (see Figure 6.1 on page 9 if using the bottom

glands or see Figure 6.2 on page 9 if using the rear glands).

.

Fig. 6.1 Feeding the Wire using the Bottom NPT Fittings

Fig. 6.2 Feeding the Wire using the Rear NPT Fittings

3.Prepare the surface for mounting and install the J-mount.

Fig. 6.3 Mounting the J-mount and Housing

4.Place the UHI-SBG-0 housing on top of the J-mount while feeding the wires through the bottom or rear NPT fittings.

5.Make sure that the weight of the camera is distributed evenly.

Bosch Security Systems, Inc. Installation Manual September 15, 2006 F01U032279_01