AutoDome Power Supply Boxes Installing the Power Supply Box | en 15
Bosch Security Systems, Inc. Installation Guide F.01U.250.895 | 1.0 | 2011.08
2.3 Mount the Power Supply Box
Before mounting the power supply box decide if you will be
wiring the box through the holes in the bottom or back of the
box. If wiring the box through the back, move the two (2) seal
plugs to the bottom holes before mounting.
Figure 2.1 Power Supply Box with Optional Trim Skirt
1. Use the wall mount template supplied in the packaging box
to locate the four (4) mounting holes for the power supply
box.
2. Drill four (4) holes for the mounting anchors. If installing
outdoors, apply a weatherproof sealant around each hole
at the mounting surface.
3. Place the power supply box into the optional trim skirt.
4. Secure the power supply box to the wall using four (4)
corrosion-resistant stainless steel studs (not included).
NOTICE!
Use 3/4-inch NPS (20-mm) fittings for the holes on the bottom
and back of the box. Use 1/2-inch NPS (15-mm) fittings for the
side holes.
NOTICE!
A stud diameter of 6.4 mm (1/4 in.) or 8 mm (5/16 in.), able to
withstand a 120 kg (265 lb) pull-out force is recommended.