Bosch Appliances WTXD5500UC manual Installation stepbystep, Preparing Transport, Dryer Step

7. Close the door and secure with adhesive tape.

8. Screw the height>adjustable feet of the dryer into the housing to prevent them from being damaged during transportation.

Installation ( step￿by￿step

1.Unpack the dryer.

2.Remove all objects from the drum.

3.Check the dryer for visible damage.

4.Position the dryer near the installation location.

5.If required, have customer service change the door hinges

to the left (see page 7).

6.If required, have customer service install the exhaust air outlet on the dryer (see￿page￿9).

￿Switch the dryer to •Extra Dry" and then press the Start button.

￿After 3-5 minutes press the Stop button and open the door.

6.If the interior of the dryer feels warm, the dryer has been connected properly.

Switch the dryer to •off".

7.If the dryer does not work, switch the dryer to •off". Look in the troubleshooting section (page 24) of the

OPERATING INSTRUCTIONS and find the fault.

7.	Have	the gas	supply connected			Preparing			to	transport
	by an	qualified	technician (see			the dryer			(	step
	page	8).		The dryer should be level	with
						by￿step
8.	Install	exhaust	duct,
				all four feet firmly on the		1.	Close	the	shut>off valve.
	if￿necessary.			ground. The dryer must not
	Follow	the installation		wobble. If￿the dryer is not	level	2.	Rotate	the	programm selector

instructions

supplied

by

the

or if it does wobble, the

feet

to •OFF".

appropriate

manufacturer!

must be adjusted. Adjust

the

3.

Pull

out

the

power

supply

plug

height>adjustable

feet

until

the

or

i

If

space

is

very restricted,

it

is

dryer does not rock and

is level,

turn

off

the

circuit

breaker.

recommended

to fit

the initial

both front>to>back and

4.

Disconnect

gas

supply

side>to>side.

parts

of

the

exhaust

duct

to

the

5.

Disconnect

the

exhaust

duct

dryer

before

the dryer

is

moved 11.

Connect the

exhaust

duct

to

from

the

exhaust air outlet

on

to

its

final

installation

location.

the exhaust

air

outlet on

the

the

dryer.

dryer.

9.

Move

the dryer to its

final

6.

Place any

accessories

in the

12.

Insert plug into

the

wall

location

and

align.

drum.

receptacle.

￿ CAUTION ￿

Do not slide dryer across the floor if height>adjustable feet have been extended. Feet and/or dryer base may be damaged if dryer is slid across floor with height>adjustable feet extended.

10.Position and then level the dryer.

Check list before using the dryer

1.Check that steps 1-12 have been implemented properly.

2.Ensure that the dryer is connected to the power supply.

3.Open the shutoff>valve.

4.Read the operating instructions to understand how your dryer operates.

5.Conduct an appliance test:

￿Check that the drum is empty.

￿Close the dryer door.

12