Cleaning and care
Cleaning the dryer
DANGER
RISK OF EXPLOSION!
Never use solvents or highly flammable liquids for cleaning.
3. Remove the lint filter.
Vacuum and reconnect the duct.
WARNING
Remove gas connection before moving the dryer to clean the duct. Be careful not to destroy the gas connection when cleaning the duct.
Cleaning the moisture sensor
|
| CAUTION |
|
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Incorrect | cleaning may | damage |
|
|
|
|
|
| |||||||
the dryer. Do not spray with | a |
|
|
|
| ||||||||||
water | jet. | Do | not use | scouring |
| 4. Remove | lint | by | stroking your | ||||||
agents | or | all0purpose |
| cleaners. |
|
| |||||||||
|
|
| hand over | the | filter. | ||||||||||
Do | not | use steam cleaners. |
|
| |||||||||||
|
|
|
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
| The filter should be rinsed once a | ||||
|
|
|
|
|
|
|
|
|
|
| |||||
Wipe | the | housing and | fascia with a |
|
|
| |||||||||
soft cloth | and | soapy | water | only. | year under warm running water. | ||||||||||
The filter must be dried thoroughly | |||||||||||||||
|
|
|
|
|
|
|
|
|
|
| |||||
Wipe | the | drum, | door | seal | and |
| before being | replaced. | |||||||
inside |
|
|
| ||||||||||||
of the | door | with a damp | cloth |
| only. |
|
|
| |||||||
Cleaning the lint filter
A dirty filter extends the drying time and increases energy consumption.
The filter should be cleaned before and after each drying process, however at the latest when the •lint filter" indicator light illuminates.
If the •lint filter" indicator light | 5. | Insert | the | filter. |
illuminates during a drying program | 6. | Close | the | door. |
and a warning signal is emitted, |
|
|
|
|
clean the filter immediately and | Cleaning | the exhaust | ||
check the exhaust duct. | duct |
|
| |
The moisture sensor has to be cleaned because a fine layer of transparent buildup is deposited onthe sensors.
This deposit can easily be removed by wiping the sensors (the two bars next to the lint filter) with a cloth and alittle white vinegar.
Use white vinegar only!
Clean the moisture sensor once a month.
Cleaning the bearing shield
Over time, fluff from the drying process collects in the bearing shield.
iThe program interrupts automatically.
1.Switch off the dryer. Program selector to •off".
CAUTION
Inspect and clean the exhaust ducting at least once a year to prevent clogging. A partially clogged exhaust can lengthen the drying time.
Turn off the circuit breaker
The inside of the door heats up Pull out power supply plug during the drying process.
2. Open the door.
This fluff can be easily removed using your vacuum cleaner, at least once a month.
23
