Bosch Power Tools 11250VSRD manual Assembly, Removing SDS-plusACCESSORIES, Hand Grip

BM 1619P02168 12-07 12/5/07 3:52 PM Page 7

Assembly

!WARNING Disconnect the plug from the power source before

making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.

INSTALLING SDS-plus®ACCESSORIES

Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant

Insert accessory into the chuck through the dust shield, while twisting and pushing inward until it locks automatically into place. Pull outward on the accessory to be certain it is locked into the chuck (Fig. 2).

FIG. 2	SDS-plus®
	CHUCK

DUST

SHIELD

NOTE: The high efficiency available from the rotary hammers can only be obtained if sharp and undamaged accessories are used. The "cost" to maintain sharp and undamaged accessories is more than offset by the "time saved" in operating the tool with sharp accessories.

REMOVING SDS-plus®ACCESSORIES

!Accessories may be hot after WARNING use. Avoid contact with skin

and use proper protective gloves or cloth to remove.

To remove an accessory, pull locking sleeve backward and pull bit forward. All accessories should be wiped clean after removing (Fig. 3).

FIG. 3

BB

LOCKING

SLEEVE

OFFSET AUXILIARY HANDLE	FIG. 4
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚.

To reposition and/or swivel the handle, loosen the hand grip, move the handle to the desired position along the barrel and securely retighten the hand grip (Fig. 4).

							re	r
						me
					mm
				ma
			ha
		h
	ch
ssc
Bo

HAND GRIP

-7-