BM 1619929800 12-07 12/4/07 8:32 AM Page 10

INSTALLING & REMOVING ACCESSORIES

 

FIG. 6

3-JAW CHUCK

 

For small bits, open jaws enough to insert the

 

bit up to the flutes. For large bits, insert the bit

 

as far as it will go. Center the bit as you close

 

the jaws by hand. This positions the bit

 

properly, giving maximum contact between the

 

chuck jaws and the bit shank (Fig. 6).

 

To tighten chuck, insert key into each of the

 

three key holes in succession and tighten

 

clockwise firmly.

 

The chuck can be released by using one hole only.

 

Note: The 3-Jaw Chuck is for use only in “Drill

 

only” mode. The 3-Jaw Chuck is not for use

 

when drilling with hammering action.

 

AUXILIARY HANDLE

The auxiliary handle will provide additional control, support and guidance for the tool. The handle is adjustable around the 360° handle collar mount.

To mount, loosen wing knob and slide handle completely over chuck onto the collar mount and tighten wing knob (Fig. 7).

FIG. 7

WING KNOB

AUXILIARY

HANDLE

DEPTH GAUGE

Your drilling depth can be pre-set and/or repeated by using the depth gauge.

Setting depth: After the auxiliary handle is installed, make sure the accessory has been fully inserted into the tool holder before setting the depth gauge (Fig. 8).

To adjust depth, push down on the depth gauge release lever, slide the depth gauge to desired depth and release pressure on lever to lock the depth gauge in place (Fig. 8).

FIG. 8

DEPTH GAUGE

RELEASE LEVER

DEPTH GAUGE

-10-

Page 10
Image 10
Bosch Power Tools 11536C manual Installing & Removing Accessories JAW Chuck, Auxiliary Handle, Depth Gauge Release Lever