10 English
Assembly
For Your Safety
fWarning! Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled.
Aquatak Clic 125/Aquatak Clic 130
Your pressure washer is double insulated for safety and requires no earth connection. The op- erating voltage is 230 V AC, 50 Hz (for
Aquatak Clic 135/Aquatak Clic 140
Your pressure washer requires an earth connec- tion. The operating voltage is 230 V AC, 50 Hz (for
If you want to use an extension cable when op- erating your high pressure washer, only the fol- lowing cable dimensions should be used:
-1.5 mm2 – max length 20 m
-2.5 mm2 – max length 50 m
Note: If an extension cable is used it must be earthed and connected through the plug to the earth cable of your supply network in accord- ance with prescribed safety regulations.
If in doubt contact a qualified electrician or the nearest Bosch Service Centre.
fWARNING! Inadequate extension cables can be dangerous. Extension cable, plug and socket must be of watertight construc- tion and intended for outdoor use.
Cable connections should be kept dry and off the ground.
It is recommended for increased electrical safe- ty to use a Residual Current Device (RCD) with a tripping current of not more than 30 mA. Al- ways check your RCD every time you use it.
If the supply cord is damaged, it must be re- placed by a Bosch Service Centre.
Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fit- ted in its place by an authorised customer serv- ice agent. The replacement plug should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible shock hazard and should never be in- serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid- ual current device (RCD) with a rated residual current of 30 mA or less.
Assembly
Assembly of Product (see figure A)
Fix the top handle 1 to the pressure washer us- ing screws 12.
Fix the holder to the pressure washer using screws 13.
Slide detergent tank into position as shown.
Connecting high pressure gun to lance (see figures B and E)
Insert the 4
Connecting high pressure hose to gun (see figures C–D)
Join high pressure hose to gun as shown.
Secure with clip 14 as shown, check if secure by pulling on high pressure hose.
Water connection (see figures H and J)
Screw inlet connector 5 onto machine water in- let connection 15.
Attach water supply hose (not supplied) to the mains water supply and machine.
High pressure hose/Supply cable (see figures I and K)
Pull out the pressure hose 3 and supply cable 6 of the pressure washer.
F 016 L70 545 (14.1.11) | Bosch Power Tools |