BM 2610006360 03-09:BM 2610006360 03-09 3/18/09 1:42 PM Page 11

Operating Instructions for Saw

!WARNING Disconnect the plug from the power source before

making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.

When working, never hold tool with your hand or fingers in area of the saw blade. The fingers of the guiding hand must always be kept behind the limiting ridge (Fig. 14).

FIG. 14

POSITIONING THE BLADE

AGAINST THE WORK

Never saw with the blade ! WARNING facing upward or in the

direction of the body (Fig. 15).

FIG. 15

1640VofessionalS r P

LIMITING

RIDGE

SLIDE "ON/OFF" SWITCH

The tool is switched "ON" by the slide switch located on the topside of the motor housing.

TO TURN THE TOOL "ON", slide the switch button forward.

TO TURN THE TOOL "OFF", slide the switch button backward.

VARIABLE SPEED DIAL

Your tool is equipped with a variable speed dial. The blade stroke rate may be adjusted during cutting operation by setting the dial on or between any one of the six numbers.

The optimum stroke rate depends on the material and must be determined by testing on similar materials in each application.

The cutting action of this saw is similar to a handsaw.

Place the blade on the edge of the work- piece. The blade should be held at a steep angle to the workpiece approx. 60° (Fig. 16A.)

It is difficult to begin cutting on the flat of a workpiece (Fig.16B).

FIG. 16

60°

AB

Pull blade thru the workpiece maintaining a steep angle when cutting (Fig. 17A).

Do not start cutting on the back edge and allow tip to plunge into workpiece (Fig. 17B)

FIG. 17

AB

-11-

Page 11
Image 11
Bosch Power Tools 1640VS manual Operating Instructions for Saw, Positioning the Blade Against the Work, Slide ON/OFF Switch