Bosch Power Tools 1640VS manual Assembly, FLUSH-CUT SAW Blade, General Purpose SAW Blade

BM 2610006360 03-09:BM 2610006360 03-09 3/18/09 1:42 PM Page 8

Assembly

INSERTING AND CHANGING THE BLADE The machine is equipped with a Bosch "Clic" blade-clamping device. This feature makes changing blades simple and fast without additional tools.

FLUSH-CUT SAW BLADE

This blade’s teeth are offset from the blade guide, which facilitates flush cutting. The flush-cut saw blade can be attached to the tool depending on desired sawing direction, or personal preference figures A or B).

A B

FIG. 3

Hook the respective small tab for sawing direction (A) or (B) completely onto hook as shown in figures 4 or 5 depending on personal preference.

Then swing the saw blade in the direction of the arrow and press the large tab onto the locking spring until it latches.

FIG. 4	HOOK
SMALL
TAB
	DRIVE
	PIN
LARGE	LOCKING SPRING
TAB
FIG. 5	HOOK

SMALL

TAB DRIVE

PIN

LARGE
TAB	LOCKING SPRING

If necessary, wipe the blade clean. Only then should the saw teeth protector be removed.

Insert plug into power source and turn tool on briefly (See Operating Instructions for Saw Section). This will allow the saw blade pin to engage into the blade to drive the blade back and forth. Turn tool off.

To change the blade, place the saw teeth protector onto the blade and press the “Clic” button. This causes the tab to spring out of the locking spring, then remove the blade.

GENERAL PURPOSE SAW BLADE

The general purpose saw blade can also be attached depending on desired sawing direction or personal preference (Fig. 6).

FIG. 6

“CLIC“

BUTTON

BLADE

BLADE

Hook the respective small tab for sawing direction (C) or (D) completely onto hook as shown in figures 7 or 8 depending on personal preference.

Then swing the saw blade in the direction of the arrow and press the large tab onto the locking spring until it latches.

HOOK

FIG. 7

SMALL TAB

	DRIVE
	PIN
LARGE
TAB	LOCKING
	SPRING

-8-