RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Front Cover Assembly (830182-02)
Refer To Drawing 8301XX.
TTR: 5 minutes.
Step | Procedure |
|
|
1 | Unplug the power cord from the printer. |
|
|
2 | Raise the Rear Pivot Cover and open the Upper Imaging Assembly. |
|
|
3 | Loosen the top two corner Screws (130987) found just behind the top edge of |
| the Front Cover. |
|
|
4 | Close the Upper Imaging Assembly. |
|
|
5 | Remove the Screw (130987) by the Card Hopper and the Screw (130987) by the |
| Card Exit Ramp. |
|
|
6 | Lift the front cover just enough so the top screws come away from the printer |
| chassis. |
|
|
7 | Lay the front cover down. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 117 |
|
