FARGO electronic C10, M10 service manual Specifications

RESTRICTED USE ONLY Fargo Electronics, Inc.

Section 1: Specifications

Safety Messages (review carefully)

Symbol	Critical Instructions for Safety purposes
Danger:	Failure to follow these installation guidelines can result in death or
	serious injury.
	Information that raises potential safety issues is indicated by a warning
	symbol (as shown to the below).
	• To prevent personal injury, refer to the following safety messages
	before performing an operation preceded by this symbol.
	• To prevent personal injury, always remove the power cord prior to
	performing repair Instructions, unless otherwise specified.
	• To prevent personal injury, make sure only qualified personnel
	perform these Instructions.
Caution:	This device is electrostatically sensitive. It may be damaged if
	exposed to static electricity discharges.
	Information that raises potential electrostatic safety issues is indicated
	by a warning symbol (as shown to the below).
	• To prevent equipment or media damage, refer to the following
	safety messages before performing an operation preceded by this
	symbol.
	• To prevent equipment or media damage, observe all established
	Electrostatic Discharge (ESD) Instructions while handling cables in
	or near the Circuit Board and Printhead Assemblies.
	• To prevent equipment or media damage, always wear an
	appropriate personal grounding device (e.g., a high quality wrist
	strap grounded to avoid potential damage).
	• To prevent equipment or media damage, always remove the
	Ribbon and Cards from the Printer before making any repairs,
	unless otherwise specified.
	• To prevent equipment or media damage, take jewelry off of
	fingers and hands, as well as thoroughly clean hands to remove oil
	and debris before working on the Printer.

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) 9