RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Adjusting the RP2 Potentiometer
Note: RP2 has two stops; do not turn the screw beyond these stops.
Once both LEDs are OFF, the ribbon sensor calibration is completed. Then, follow these steps.
Step | Procedure |
|
|
1 | Remove the POWER cable, the tape from over the Lid Switch, and the note |
| pad. |
|
|
2 | Return Switch number one to the OFF position; move it towards the front of the |
| printer. |
|
|
3 | Replace the ribbon (if necessary). |
|
|
4 | Close the Top Lid. |
|
|
5 | Apply power when ready. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 102 |
|
