RESTRICTED USE ONLYFargo Electronics, Inc.
Replacing the Printhead Harness Assembly (830162-00) (cont.)
Step | Procedure |
|
|
13 | Remove the Screw (130972) that secures the Headlift Sensor Switch to the |
| Front Plate/Print Assembly Sideplate (830302). |
|
|
14 | Lift the Headlift Sensor Switch out of the printer. |
|
|
15 | Cut the Tie Wrap (140013) that attaches the Head Harness Assembly to the |
| Back Plate/Print Assembly Sideplate (830303). |
|
|
16 | Remove the Rear Pivot Cover. |
|
|
17 | Refer to drawing 8301XX to remove the Screw (130971), Screw (130939), |
| Washer (130949), and Cable Clamp (140013) from the Power Circuit Board |
| Power (drawing 830179). |
|
|
18 | Lift up on the Backplate; guide the Power Circuit Board over the lip of the printer |
| baseplate. |
|
|
19 | Locate the cable connections. |
|
|
20 | Place a small piece of tape on each cable; write the cable connection location on |
| that tape. |
|
|
21 | Disconnect the cable connections. |
|
|
22 | Take the Printhead Harness Assembly from the printer. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 122 |
|
