FARGO electronic C10, M10 service manual Replacing the Headlift Motor Assembly

RESTRICTED USE ONLY Fargo Electronics, Inc.

Replacing the Headlift Motor Assembly (830143)

Caution: This device is electrostatic sensitive. It may be damaged if exposed to static electrical discharges. (Discharges may be generated by various means, such as walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge (ESD) procedures while handling cables in or near the Circuit Board and Printhead Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum, make positive contact with the bare metal chassis of the printer with the hand before proceeding with the procedure.

Refer To Drawing 830117-XX. TTR: 10 minutes.

Step	Procedure
1	Unplug the power cord from the printer.
2	Remove the two Screws (130938) from the Headlift Motor Assembly. (Note:
	The Headlift Motor Assembly is connected to the Headlift Motor Spacer and the
	Headlift Gear; they will be loose once the Headlift Motor Assembly is removed.)
3	Disconnect the cable connection from J15 on the Print Circuit Board. See
	Drawing 830145 for specifications.
4	Take the Headlift Motor Assembly from the printer. (Note: Apply a liberal
	amount of grease to the teeth of the worm gear when installing the new Headlift
	Motor Assembly. Be sure the dimples of the Headlift Motor Spacer are fitted to
	the associated openings on the Chassis Assembly. Also be sure the end Shafts
	of the Headlift Gear fit properly into the associated openings in the Chassis
	Assembly, Headlift Motor Spacer, and the Headlift Motor Assembly before
	tightening the two Screws.)

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) 127