FARGO electronic M10, C10 service manual Controlling the Resin Heat

RESTRICTED USE ONLY	Fargo Electronics, Inc.
Controlling the Resin Heat
Step Procedure

1Control the amount of heat the Printer uses when printing with the resin black panel(s) of a full-color ribbon or when printing with a resin-only ribbon by adjusting the Resin Heat.

Note #1: This control can be helpful for fine-tuning the saturation of resin text and bar codes.) Adjust the Resin Heat (K) setting (as needed), as shown below.

Note #2: This option only effects objects printed with a resin-only print ribbon or those objects printed on the back side of a card with the resin black panel of a YMCKO, YMCKOK, or YMCKK print ribbon.

Note #3: Use this option to control the amount of heat the Printer uses when printing with the resin black panel(s) of a full-color ribbon or when printing with a resin-only ribbon, adjust the Resin Heat slide.

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) 62