RESTRICTED USE ONLYFargo Electronics, Inc.
Replacing the Left Card Input Roller
Step | Procedure |
|
|
1 | Unplug the power cord from the printer. |
|
|
2 | Take off the Rear Pivot Cover. |
|
|
3 | Detach the Print Circuit Board from the chassis. Do not remove any wire |
| connectors unless indicated. |
|
|
4 | Stand at the front of the Chassis Assembly; remove the Retaining Ring |
| (140048) from the Card Input Roller Shaft. |
|
|
5 | Remove the Transport Roller Gear.Be sure to note that the wide part of the |
| gear hub faces the Sideplate. Remember this when reinstalling it. |
|
|
6 | Remove the Washer Spring (130951). Be sure to note that the wave of the |
| spring faces out. Remember this when reinstalling it. |
|
|
7 | Stand at the rear of the Chassis Assembly; remove the Ribbon Drive |
| Assembly. |
|
|
8 | Remove the Retaining Ring (140062) from the Card Input Roller Shaft. |
|
|
9 | Remove the two Drive Roller Bearings (760343) from the Card Input Roller. |
|
|
10 | Guide the Shaft forward and out of the rear Sideplate. |
|
|
11 | Angle the Card Input Roller up. |
|
|
12 | Slide the Shaft out of the front Sideplate. |
|
|
13 | Take the Card Input Roller out of the printer. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 137 |
|