RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Lid Sensor Assembly (830150)
Caution: This device is electrostatic sensitive. It may be damaged if exposed to static electrical discharges. (Discharges may be generated by various means, such as walking on a carpeted floor.) Be sure to observe all established
Refer To Drawing
Step | Procedure |
|
|
1 | Unplug the power cord from the printer. |
|
|
2 | Remove the Screw (130972) from the Lid Sensor Assembly. |
|
|
3 | Disconnect the cable connector from J4 on the Print Circuit Board. See |
| Drawing 830150 for specifications. |
|
|
4 | Take the Lid Sensor Assembly from the printer. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 131 |
|