RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Card Feed Roller (810304)
Refer To Drawing
TTR: 15 minutes.
Step | Procedure |
|
|
1 | Unplug the power cord from the printer. |
|
|
2 | Take off the Rear Pivot Cover. |
|
|
3 | Detach the Print Circuit Board from the chassis. Do not remove any wire |
| connectors unless indicated. |
|
|
4 | Stand at the front of the Chassis Assembly; remove the Retaining Ring |
| (140062) from the Card Feed Roller Shaft. |
|
|
5 | Remove the Drive Roller Bearing (760343) from the front Sideplate. |
|
|
6 | Stand at the rear of the Chassis Assembly; remove the Retainer Clip (130950) |
| from the Card Feed Roller Shaft. Refer to Drawing |
|
|
7 | Slide the Card Feed Roller forward — away from the rear Sideplate. (Note: |
| The Card Feed Shaft Gear and Drive Roller Bearing are attached at the rear |
| Sideplate; they will be loose when the Card Feed Roller is removed. When |
| replacing the Card Feed Roller, hold the Card Feed Shaft Gear in place so the |
| notched end of the Shaft slides easily into the Card Feed Shaft Gear.) |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 138 |
|
