RESTRICTED USE ONLY

Fargo Electronics, Inc.

Replacing the Print Circuit Board (140300)

Refer To Drawing 830179.

TTR: 10 minutes

Step

Procedure

 

 

1

Unplug the power cord and any external cables from the printer.

 

 

2

Refer to drawing 8301XX to remove the Screw (130971), Screw (130939), Washer

 

(130949), and Cable Clamp (140013) from the Power Circuit Board Power

 

(drawing 830179).

 

 

3

Lift up on the Backplate; guide the Power Circuit Board over the lip of the printer

 

baseplate.

 

 

4

Place a small piece of tape on each cable; write the cable connection location on

 

that tape.

 

 

5

Remove all of the cables from the Circuit Boards.

 

 

6

Remove the two Screws (130971) that secure the Print Circuit Board to the two

 

Standoff Screws (140047).

 

 

7

Use the thumb and index fingers of both hands to carefully pry the Print Circuit

 

Board from the Power Circuit Board. (Note: Attach the cables. Be sure to calibrate

 

the printer so it functions properly. See related Safety Messages.)

 

 

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)

118

 

Page 118
Image 118
FARGO electronic M10, C10 service manual Replacing the Print Circuit Board