FARGO electronic M10, C10 service manual Replacing the Slotted Sensor Mount Assembly

RESTRICTED USE ONLY Fargo Electronics, Inc.

Replacing the Slotted Sensor Mount Assembly (830149)

Caution: This device is electrostatic sensitive. It may be damaged if exposed to static electrical discharges. (Discharges may be generated by various means, such as walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge (ESD) procedures while handling cables in or near the Circuit Board and Printhead Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum, make positive contact with the bare metal chassis of the printer with the hand before proceeding with the procedure.

Refer To Drawing 830117-XX. TTR: 5 minutes.

Step	Procedure
1	Unplug the power cord from the printer.
2	Remove the Screw (130938) from the Slotted Sensor Mount Assembly.
3	Disconnect the cable connector from J7 on the Print Circuit Board. See
	Drawing 830149 for specifications.
4	Take the Slotted Sensor Mount Assembly from the printer.

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) 130