RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Printhead Harness Assembly (830162-00)
Refer To Drawing
Note: The Printhead Harness Assembly includes the following cables: Data and Power Bus cables for the Printhead, Cooling Fan, Ribbon Sensor Board Assembly, and the Headlift Sensor Switch.
Step | Procedure |
|
|
1 | Unplug the power cord from the printer. |
|
|
2 | Raise the Rear Pivot Cover. |
|
|
3 | Lift the Head Latch Lever and raise the Upper Imaging Assembly. |
|
|
4 | Unscrew the two Thumb Screws (130887). |
|
|
5 | Remove the Head Cover Plate (820253). |
|
|
6 | Raise the tip of the Head Spring (810214) about |
| Assembly (820199). |
|
|
7 | Grasp the two plastic forks on each side of the Printhead Assembly, pivot them |
| upward, and release the Head Spring. |
|
|
8 | Disconnect the two cables from the printhead. Make a note as to how the cables |
| are oriented for installing the replacement Printhead. |
|
|
9 | Pivot the Printhead Assembly back to its normal position. |
|
|
10 | Take the two Screws (130990) from the Fan Guard (150312); lift the fan out of |
| the printer. |
|
|
11 | Remove the two Screws (130971) that secure the Shield Sensor (810303) to the |
| Sensor Mount Bracket (810221). |
|
|
12 | Take the Ribbon Sensor Assembly from the printer. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 121 |
|