RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Printhead Assembly (820102)
Refer To Drawing
Caution: If oil or debris makes contact with the Printhead elements, wipe the glasscoated area of the printhead immediately with a clean cloth dampened with 99% pure alcohol.
Step | Procedure |
|
|
1 | Unplug the power cord from the printer. |
|
|
2 | Raise the Rear Pivot Cover. |
|
|
3 | Lift the Head Latch Lever and raise the Upper Imaging Assembly. |
|
|
4 | Unscrew the two Thumb Screws (130887). |
|
|
5 | Remove the Head Cover Plate (820253). |
|
|
6 | Raise the tip of Head Spring (810214) about |
| Assembly (820199). |
|
|
7 | Grasp the two plastic forks on each side of the Printhead Assembly, pivot them |
| upward, and release the Head Spring. |
|
|
8 | Disconnect the two cables from the printhead. Make a note as to how the |
| cables are oriented for installing the replacement Printhead. |
|
|
9 | Guide the Printhead Assembly between the sideplates and out of the printer. |
| See related Safety Messages. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 120 |
|