RESTRICTED USE ONLYFargo Electronics, Inc.
Installing the New Magnetic Head Assembly
Step | Procedure |
|
|
1 | Position the new magnetic head in the Access Plate area. |
|
|
2 | Work the cable connector through the opening to the baseplate area. |
|
|
3 | Connect the cable connector at J18 on the Print Circuit Board. |
|
|
4 | Attach the Print Circuit Board to the baseplate. |
|
|
5 | Replace the Rear Pivot Cover. |
|
|
6 | Turn the printer upside down. |
|
|
7 | Position the two Magnetic Head Spacers if using 30 mil thick cards; they can |
| be removed for 10 mil thick cards. |
|
|
8 | Remove the plastic cover from the Magnetic Head Assembly. |
|
|
9 | Position the Magnetic Head Assembly in place. |
|
|
10 | Secure it with the two Screws. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 140 |
|
