RESTRICTED USE ONLYFargo Electronics, Inc.

Resolving problems with Ribbon winding and printing

Step Procedure

1Gently insert the tip of a small flathead screw Driver into the hole so it fits into the slot of RP2. Slightly rotate RP2 in either direction until both the on-line and On/Cancel LED’s turn OFF.

Caution: RP2 cannot be rotated all the way around. It has a stopping point in each direction. Do not rotate RP2 beyond these points.

2Once both LED’s are OFF, Ribbon Sensor calibration is complete.

3Remove the power cable, open the Top Cover and flip Switch 1 toward the front of the Printer to turn the switch back OFF. Close the Top Cover, reconnect the power cable and try the print job again.

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)

44

 

Page 44
Image 44
FARGO electronic M10, C10 service manual Resolving problems with Ribbon winding and printing