RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Calibrating the Left Card Sensor
When this part is moved or replaced, the lengthwise print position on cards can be affected. This sensor provides the precise position of the cards leading edge as it is presented to the printhead. If the position is incorrect, it may cause ribbon breakage between the yellow and clear panels of the ribbon.
Adjusting the RP3 Potentiometer
Step | Procedure |
|
|
1 | Locate RP3 by finding the three small holes on the |
| printer; RP3 is located within the third hole down from the top. |
|
|
2 | Install a |
|
|
3 | Run a self test print. |
|
|
4 | Measure the width of the colored bars at each end of the self test print. The |
| width of each bar should be close to equal. |
|
|
5 | Adjust RP3 counterclockwise in |
| leading edge appears thinner. If the red bar on the trailing edge appears |
| thinner, adjust RP3 clockwise in |
|
|
6 | Repeat steps |
|
|
Troubleshooting Tips
The slots of the Card Sensor may be obscured if the printer behaves as if a card is in the feed path — the main stepper motor is activating when power is applied and then the
To remove dust or debris from the card sensor, use a can of compressed air to blow between the upper and lower portions of the Left Card Sensor.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 103 |
|