FARGO electronic C10, M10 service manual Replacing the Ribbon ID Sensor Board Assembly

RESTRICTED USE ONLY Fargo Electronics, Inc.

Replacing the Ribbon ID Sensor Board Assembly (763173-2)

Caution: This device is electrostatic sensitive. It may be damaged if exposed to static electrical discharges. (Discharges may be generated by various means, such as walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge (ESD) procedures while handling cables in or near the Circuit Board and Printhead Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum, make positive contact with the bare metal chassis of the printer with the hand before proceeding with the procedure.

Refer To Drawing 830117-XX. TTR: 15 minutes

Step	Procedure
1	Unplug the power cord from the printer.
2	Take the Front Cover off.
3	Remove the Retaining Ring (140009). Use a replacement Retaining Ring when
	installing the new Ribbon ID Sensor Board Assembly.
4	Extract the Right Ribbon Hub (763345) and the Clutch Spacer (760386) off of
	the Hub Linkage Assembly (810115).
5	Move the Ribbon ID Sensor Board Assembly off of the Hub Linkage Assembly.
	Take care not to misplace the Spring; it can remain on the Hub Linkage
	Assembly.
6	Disconnect the cable connection from J10 on the Print Circuit Board. See
	Drawing 763173-X for specifications.
7	Tie a string to the cable connector and draw the string through the wire path.
	Use the string as a means of routing the the new Ribbon ID Sensor Board
	Assembly cable through the printer chassis.
8	Take the Ribbon ID Sensor Board ASsembly from the printer.

Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) 133