RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Platen Roller (810261)
Refer To Drawing
TTR: 15 minutes
Step | Procedure |
|
|
1 | Unplug the power cord from the printer. |
|
|
2 | Remove the Front Cover. |
|
|
3 | Take off the Rear Pivot Cover. |
|
|
4 | Detach the Print Circuit Board from the chassis. Do not remove any wire |
| connectors unless indicated. |
|
|
5 | Stand at the front of the Chassis Assembly; remove the Retaining Ring |
| (140048) from the Platen Roller Shaft. |
|
|
6 | Remove the Platen Card Drive Gear. Be sure to note that the wide part of the |
| gear hub faces the Sideplate. Remember this when reinstalling it. |
|
|
7 | Take off the Washer Spring (130951). Be sure to note that the wave of the |
| spring faces the Platen Card Drive Gear. Remember this when reinstalling it. |
|
|
8 | Stand at the rear of the Chassis Assembly; remove the Retaining Ring |
| (140048) from the Platen Roller Shaft. |
|
|
9 | Remove the Right Roller Gear (760400). Be sure to note that the flat part on |
| the gear hub faces away from the Sideplate. Remember this when reinstalling |
| it. |
|
|
10 | Stand at the front of the Chassis Assembly; remove the two Screws (130971) |
| that secure the Card Guide Assembly. The Card Guide Assembly does not |
| need to be removed; allow it to “float” so the Platen Roller can be removed |
| from the chassis. |
|
|
11 | Remove the two Drive Roller Bearings (760343) from the Platen Roller Shaft. |
|
|
12 | Guide the Platen Roller through the access opening in the front Sideplate and |
| out of the printer. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 135 |
|
