RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Card Feed Switch Assembly (830136)
Refer To Drawing 830131, Item 12.
TTR: NA
In the unlikely event of failure, this cable is not field serviceable. Please contact the FARGO Technical Support Group at (952)
Replacing the LED Board Assembly (830133)
Caution: This device is electrostatic sensitive. It may be damaged if exposed to static electrical discharges. (Discharges may be generated by various means, such as walking on a carpeted floor.) Be sure to observe all established
Step | Procedure |
|
|
1 | Unplug the power cord from the printer. |
|
|
2 | Take off the Rear Pivot Cover. |
|
|
3 | Detach the Print Circuit Board from the chassis. Do not remove any wire |
| connectors unless indicated. |
|
|
4 | Remove the Screw (130971) that holds the Lower Ribbon Sensor Assembly to |
| the Rear Side Plate. Refer to Drawing 830126. |
|
|
5 | Disconnect the cable connector from J12, pins 1and 2 on the Print Circuit |
| Board. |
|
|
6 | Remove the LED Board Assembly from the Bottom Sensor Bracket and the |
| printer. See Drawing 830133 for specifications. |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 134 |
|