RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Replacing the Card Input Roller (810262)
Refer To Drawing
Note: The following instructions are for the Card Input Roller near the center of the printer. Use appropriate instructions for removing the Left Card Input Roller.
Step | Procedure |
|
|
1 | Unplug the power cord from the printer. |
|
|
2 | Take off the Rear Pivot Cover. |
|
|
3 | Detach the Print Circuit Board from the chassis. Do not remove any wire connectors |
| unless indicated. |
|
|
4 | Stand at the front of the Chassis Assembly; remove the item; remove the Retaining |
| Ring (140048) from the Card Input Roller Shaft. |
|
|
5 | Take the Transport Roller Gear (810266) out of the printer. Be sure to note that the |
| wide part of the gear hub faces the Sideplate. Remember this when reinstalling it. |
|
|
6 | Remove the Washer Spring (130951). Be sure to note that the wave of the spring |
| faces the Transport Roller Gear. Remember this when reinstalling it. |
|
|
7 | Stand at the rear of the Chassis Assembly; remove the Retaining Ring (140048) |
| from the Platen Roller Shaft; this is necessary for the removal of the Idler Gear. |
|
|
8 | Take the Right Roller Gear from the printer. Be sure to note that the flat area on the |
| gear hub faces away from the Sideplate. Remember this when reinstalling it. |
|
|
9 | Remove the Retaining Ring (140063) from the Idler Pivot Post Shaft. |
|
|
10 | Take out the Idler Gear (760401). Be sure to note that the gear teeth of the center |
| hub face away from the Chassis Assembly. Remember this when reinstalling it. |
|
|
11 | Remove the Retaining Ring (140062) from the Card Input Roller Shaft. |
|
|
12 | Take the two Drive Roller Bearings (7603433) from the Card Input Roller. |
|
|
13 | Guide the Shaft forward and out of the rear Sideplate. |
|
|
14 | Angle the Card Input Roller up. |
|
|
15 | Slide the Shaft out of the front Sideplate. |
|
|
16 | Take the Card Input Roller from the printer |
|
|
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0) | 136 |
|